View RSS Feed

obd2lily

How to Solve wiTech MicroPod 2 Software Register Problem

Rate this Entry
Recently,our customers feedback the problem of wiTech MicroPod register problem.The warning massage “Device with serial number XXXXXX is not registered.Please check the knowledge base to determine how to register a device…” pop-up when run the Chrysler WiTech MicroPod 2 software.So here, OBD2TOOL engineer share the solution of this problem.

14-1

Procedures:

Right click the Professional Diagnostic Tool wiTech MicroPod Software icon,and click the “Properties”

14-2

Click “Open File Location”
14-3

Open the “app-config” file by txt editor

14-4

Locate the line with value=”5f86b7db0f4d58127d30dd7e4e44cd7f”

14-5

Then change the value ”5f86b7db0f4d58127d30dd7e4e44cd7f” to any other.Here change it to “6f86b7db0f4d58127d30dd7e4e44cd7f”(only change 5 to 6)

14-6

Save

Then run the wiTech MicroPod again

A warning massage pop-up “An internal registeration error has occurred….”,just ignore and close the massage window.

14-7

Click “Next”

14-8

Close the warning massage again,and select “off-line working” and “Finish”

14-9

If it prompt you that ”Can’t not identify the vehicle…”,just click the “Continue”

14-10

14-11
Done!
الكلمات الدلالية (Tags): chrysler micropod ii إضافة/ تعديل الكلمات الدلالية
التصانيف
Uncategorized

Comments